|
Title
|
|
|
|
Electrodeposition of highly porous Pt nanoparticles studied by quantitative 3D electron tomography : influence of growth mechanisms and potential cycling on the active surface area
| |
|
Author
|
|
|
|
| |
|
Abstract
|
|
|
|
| Nanoporous Pt nanoparticles (NPs) are promising fuel cell catalysts due to their large surface area and increased electrocatalytic activity towards the oxygen reduction reaction (ORR). Herein, we report on the influence of the growth mechanisms on the surface properties of electrodeposited Pt dendritic NPs with large surface areas. The electrochemically active surface was studied by hydrogen underpotential deposition (H UPD) and compared for the first time to high angle annular dark field scanning transmission electron microscopy (HAADF-STEM) quantitative 3D electron tomography of individual nanoparticles. Large nucleation overpotential leads to a large surface coverage of Pt roughened spheroids, which provide large roughness factor (Rf) but low mass-specific electrochemically active surface area (EASA). Lowering the nucleation overpotential leads to highly porous Pt NPs with pores protruding to the center of the structure. At the expense of smaller Rf, the obtained EASA values of these structures are in the range of these of large surface area supported fuel cell catalysts. The active surface area of the Pt dendritic NPs was measured by electron tomography and it was found that the potential cycling in the H adsorption/desorption and Pt oxidation/reduction region, which is generally performed to determine the EASA, leads to a significant reduction of that surface area due to a partial collapse of their dendritic and porous morphology. Interestingly, the extrapolation of the microscopic tomography results to macroscopic electrochemical parameters indicated that the surface properties measured by H UPD are comparable to the values measured on individual NPs by electron tomography after the degradation caused by the H UPD measurement. These results highlight that the combination of electrochemical and quantitative 3D surface analysis techniques is essential to provide insights into the surface properties, the electrochemical stability and, hence, the applicability of these materials. Moreover, it indicates that care must be taken with widely used electrochemical methods of surface area determination, especially in the case of large surface area and possibly unstable nanostructures, since the measured surface can be strongly affected by the measurement itself. |
| |
|
Language
|
|
|
|
English
| |
|
Source (journal)
|
|
|
|
ACS applied materials and interfaces. - -
| |
|
Publication
|
|
|
|
2017
| |
|
ISSN
|
|
|
|
1944-8244
| |
|
DOI
|
|
|
|
10.1021/ACSAMI.7B01619
| |
|
Volume/pages
|
|
|
|
9
:19
(2017)
, p. 16168-16177
| |
|
ISI
|
|
|
|
000401782500028
| |
|
Pubmed ID
|
|
|
|
28418651
| |
|
Full text (Publisher's DOI)
|
|
|
|
| |
|
Full text (open access)
|
|
|
|
| |
|